3D printed case frsky d4r-ii Vertical Up maximum diversity long range strong signal
45 Degree Slope Up
3D printed case with stiff antenna tubes
for Maximum Diversity
A 3D printed case for the FrSky D4R-II RX, complete with tough black straight PVC tube to support the antennas in a 45 degree Slope UP direction.
The holes where the tube pass through are checked for size before dispatch.
The antenna wire are spread at 90 degrees for maximum diversity to help with long range reception.
The case allows you to connect the side plug.
What’s in the Kit:-
- 1No. Case in the 45 degree slope up plane
- 2No. Lengths of tough PVC antenna tube.
Simple roughen up the bottom of the case, remove all dust and grease, apply a good quality double sided foam tape (not supplied)
Add a small drop of glue onto the antenna tubes to secure them in place.
Case and pipe only RX not included
These are printed in ABS