Description

FrSky X8R/L9R Antenna Spacer

3D Printed Vertical FrSky Antenna Spacer

STUBBY LONG –

This mount fits both the X8R and L9R receivers

This antenna spacer does a couple of things.

It holds the antenna at 45 degree to each other and it also holds the antenna at 90 degree to each other for maximum diversity.

The height of the mount is 48mm when the antenna are fitting the top of them are 77mm

This spacer is stuck to your craft and the antenna with go up (or down) vertically from the surface it is stuck upon

Simply used a good quality double sided foam tape (not supplied) to stick the antenna holder in position. Ensure that you roughen up the underside of the antenna mount and the surface you are sticking it too, the surface must also be free from all grease, dirt and dust. Once it is stuck on test the security of the mount.

The Mount also has 2No. 3mm holes in the base so that you can bolt it down onto your frame. This was a feature asked for by the long range flyers to ensure that the antenna mount stays permanently fixed vertical to the frame. (fixing bots not supplied with the mount)

The unit is in two parts, complete with black fixing screws

This is a 3D printed part and as such the surfaces are not totally flat or without very slight imperfection (though the quality is very good). It is printed in ColorFab XT which is a cross between PLA and ABS

The RX is not supplied in this kit its for demonstration purposes only