Description
DJI NAZA A2 – 3D Printed Protection Housing
A tough housing for your DJI Naza A2 GPS and Compass.
THIS IS THE LARGER HOUSING FOR THE A2 UNIT
Printed in ColorFab XT a cross of PLA and ABS
This tough housing has fillets around the inside to make the wall super strong.
The unit only weighs 10.3g
No fixings supplied. It can either be stuck to your antenna pole or screwed onto something.
If you need a fordable antenna pole look here.
The case has been revised since the YouTube Video it now has protection to the cable exit as shown below
The YouTube video below shows the smaller version, The A2 version is the same just larger
NAZA unit not included
NAZA GPS HOUSING
Reviews
There are no reviews yet.