3D Printing A Basic Introduction Using Cura
Quite a long video that introduces you to the world of 3D Printing
Very Basic 3D Printing – Using CURA April 2015
Very Basic 3D Printing Using CURA April 2015
very basic introduction in to 3 D printing. This video was made in 2015 ( a lot has changed since then) to the viewed along side an article I wrote for RotorWorld magazine in 2015.
Please take a look if you are new or have never seen a 3D printer working.
Please use the slide bar at the bottom of the video to skip through section as you wish.
The world of 3D printing is easy to get into and the price of printers have really come down over the years.
If you are looking to buy one do your research on-line and I would recommend one with a heated bed and one with sides, as i found when you start to print with engineering type filaments having the build volume enclosed so that you can keep the space warm and advantage to stop the prints from peeling off from the build platform.